Shackles
Alltec carries a wide range of shackles up to 600t in capacity. Additionally, we have a variety of styles including wide body, bolt type and screw pin from all major manufacturers.
Aluminum Truss Gantry
Our modular lightweight gantry systems are available to accommodate and adapt to your lifting needs. Each configuration is engineered specifically to meet your lifting requirements; capacities vary per configurations. The benefits of an aluminum truss gantry systems are:
Gantry With Track System
A track system was designed in multiple pieces to be assembled and utilized with single or dual gantry systems to avoid obstructions as needed.
Gantry
Our gantry is designed to remove and reinstall equipment for multiple runs with a capacity of up to 1000 lbs. Additionally, our design features multiple holes on the top beam for adaptability.
Slings
THE RIGHT SLINGhas adequate capacity in its applied configuration (not over sized, not undersized) meets the required safety factor meets the applicable industry codes, standards meets user/site heavy lift criteria has the right dimensions (accurate length and overall body diameter) is proof load tested, has a current inspection report, and in good condition material is […]
Conventional Lifting Frames
Our product line of adjustable frames enables you to change the frame dimension without having to switch out the inserts. Overall shipping dimensions are kept to a minimum by shipping the frames in telescoped-in position. Good to know!Alltec adjustable frame inserts match the standardized flange pattern of Alltec adjustable spreader bars. Our spreader bar end-caps […]
Adjustable Lifting Frames
Our product line of adjustable frames enables you to change the frame dimension without having to switch out the inserts. Overall shipping dimensions are kept to a minimum by shipping the frames in telescoped-in position. Good to know!Alltec adjustable frame inserts match the standardized flange pattern of Alltec adjustable spreader bars. Our spreader bar end-caps […]
Lightweight Aluminum Lifting Beam
Alltec aluminum lattice spreader is designed and built to provide solutions to lifting operations when weight is of the essence. With the heaviest spreader component being only 43Lbs all components can be hand-carried. The lattice design creates a rigid structure with exceptional bending and compression structural properties. Due to its modular design endless configurations can […]
Multi-Hole Lifting Beams
Alltec’s Modular Lifting Beam is perfect for when capacity and ease of assembly matters. The Modular Lifting Beam is ideal for lifting modules in plant environments due to its easy adjustment to offset load center of gravity. Additionally, it will reduce handling, freight, and cost by having a single system fit multiple load cases. Capacity […]
Modular Lifting Beams
Alltec’s patented Modular Lifting Beams are designed to meet the needs within the industry to set modular components with ease. The beams are accompanied by the “Bolt-Up Beam Calculator” which determines the exact capacities based on the configuration, lifting load, and location of CG. The program is especially essential in the case of offset CG’s, […]
Conventional Lifting Beams
Alltec pipe spreaders range from 4” pipe to 36” pipe. Capacities range from as little as a few Ton up to well over 1200Ton. However, many times it is not (just) the capacity but the length what matters. Alltec carries spreader bars with a WLL over 500T at 70ft. Specially designed adaptors enable combining (2) […]
Adjustable Lifting Beams
If you have multiple lifts coming up requiring spreader bar lengths in a similar range, then the Alltec adjustable telescopic spreader bars are your best fit. No need to change pipe insert in between lifts, no need to change out a bolted insert. Just lower the spreader on its legs, adjust the length and secure […]